- 10 -
• This child car seat is a child restraint system of the category „Semi-Universal“
and ts into all vehicles which are suitable for the installation of a „Semi-Uni-
versal“ child restraint system.
• This child restraint system has been classied in the „Semi-Universal“ ca-
tegory according to stricter approval criteria than previous models that no
longer meet these new requirements.
• Only suitable for vehicles with 3-point safety belt (xed or with retractor) ac-
cording to UN/ECE Regulation No 16 or equivalent standard.
• If in doubt, contact the manufacturer of the restraint system or your dealer.
Installation with Isox bracket
1. Extend the Isox connectors (B) to the maximum length using the button for
extending the Isox connectors (C) (see Fig. 1).
2. Now guide the extended Isox connectors to the Isox hooks on your car
seat and press them until the Isox connectors engage (see Fig. 2) and the
marking on the Isox connectors switches from RED to GREEN.
3. Now you can push the child car seat as close as possible to the backrest of
your car seat (see Fig. 3).
4. Now put the child inside.
5. Fasten the child with the vehicle‘s 3-point seat belt and make sure that it
is properly engaged. For the belt run, please refer to the adjacent drawing.
6. Group 2 (15-25 kg): Diagonal and lap belt run under the armrest.
7.
Group 3 (22-36 kg): Diagonal belt runs over, the lap belt under the armrest of
the child car seat.
8. Make sure that the belt is tight and not twisted.
Removal of the child car seat with Isox bracket
1. Press the release button (C) on both sides of the child car seat and pull it
away from the backrest of your car seat.
EN
1 2 3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
