Need help?Do you have a question about the OSD Audio PAM 245 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Sensitivity | 1V |
| Signal-to-Noise Ratio | > 90dB |
| Inputs | RCA |
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 20k ohms |
| Output Impedance | 4Ω - 8Ω |
| Outputs | Binding Post |
| Impedance | 4Ω - 8Ω |
Disconnect power immediately if the unit gets wet or foreign material enters.
Turns specific speaker runs on or off via front panel buttons or IR remote.
Five outputs for connecting speakers to 70V or 4/8 Ohm configurations.
Changes output format between 4/8 Ohms single output and 70V zoned outputs.
Offers single-channel 4 Ohms and 8 Ohms outputs.
Allows MIC1 to take priority, muting other audio sources during paging.
Instructions for connecting speakers to the 5 zoned speaker connections.
Information on using 70V constant line voltage and impedance matching for speakers.
Amplifier features voice activated priority page circuit, muting program material.
Details the functions of the remote control buttons: Power, System Lock, Mute, Vol Up, Vol Down.
To Next Page
