oset MX-10 2018 - Wiring

27
MAINTENANCE, CLEANING & STORAGE
• Keep your OSET clean and dry. Clean using the recommended procedure (see be-
low).
• Check all components for ghtness and adjustment, including handlebars, levers,
axles, chain, brakes.
• Check the wheel spokes for ghtness. It is normal for spokes to loosen in
operaon. PLEASE CHECK aer every inial ride, and then regularly aerwards.
If you need guidance please consult a skilled wheel builder or call OSET customer
services.
• Check the speed, power and response seng before each ride.
• Check the res for proper inaon. Also, inspect the res for damage.
CLEANING
Cleaning and maintaining your OSET correctly will provide a more enjoyable ownership
and riding experience. By hand cleaning the bike, you can simultaneously inspect all of the
components. We recommend cleaning be done with a damp cloth and slow running wa-
ter.
Care must be taken when washing. This is an electric machine and water should never
reach sensive components. If a hose is used, cover sensive parts.
Water and electrical components do not mix! Do not get water onto the controller,
throle or wiring. Failure to follow this instrucon could result in permanent damage, and
WARNING!
LONG TERM STORAGE
MAINTAINING YOUR OSET
If you do not plan to use your OSET for an extended period of me (1 month or more),
remove the baery from the bike for storage.
• Charge the baery to between 30 & 50% before storing.
• Ensure the baery is turned o before storage.
• Check baery voltage & top up charge every 3 months of storage if necessary.
• Store the baeries in a cool (50º to 70ºF, 10º to 21ºC), dry place. Avoid direct exposure
from the sun.
If you have any quesons about the baeries or their usage, please do not hesitate to
contact your local dealer or the OSET Customer Service Department.
28
WIRING
Your OSET is an electric bike, and features a considerable number of electrical components
and wiring. All must be protected from water and dirt! The components are listed below:
Controller: Shown below. This is the ‘brains’ of the drive system. It is a sophiscated and com-
plex component and is non-serviceable.
Throle: This sends an electronic signal to the controller, which is then interpreted to de-
termine the power required and the voltage to be sent to the motor. The throle is a non-
serviceable component. It must be protected from water.
The throle contains a small circuit board that can be damaged by water. Similarly, the
connecon between the throle and controller must be protected from water at all mes.
Baeries: There is one, sealed lithium baery included with the OSET bike.
Motor: The motor is the end of the line where the power is actually delivered. The motor is
made up of many components. Any servicing must be carried out by trained technicians only.
Please do not aempt to separate or dismantle the motor in any way.
Relay: The relay is acvated by the switch. It makes a 48v connecon that allows power to be
pulled from the baeries to the controller and ulmately to the motor. The relay has con-
necons that should not be touched unless the baeries are disconnected. The relay is a non-
serviceable item. Shown below.
Several other components make up the electrical system, such as the switch, the charge port,
the speed switch, the response dial etc.
There are no user serviceable elements incorporated into the motor, controller, baeries,
baery charger, throle, or wiring harness of your OSET electric bike. DO NOT ATTEMPT
TO DISASSEMBLE OR ADJUST ANY OF THESE COMPONENTS. Doing so may cause extensive
damage to these components, will void your warranty, and may cause a hazardous
condion. If you cannot resolve a problem using this owners manual, contact your
OSET authorized dealer, or call the OSET Customer Service Department for assistance.
WARNING!
Main fuse Relay Controller