grinding stones work evenly.
e) Please always keep the machine and its parts clean (such as: electronic components,
blower, and bearings ) and fuel them.
f) Once the knife band is worn out, please replace to prevent from danger.
g) After moving and installing machine, please do keep machine in horizontal.
h) Please do not replace any parts of the machine, and do leave the maintenance to
professional technician.
i) Before operating, please do read the instruction manual.
【
B
】
ASSEMBLY
1 Assembly of frame (see fig.3).
Mount the upper frame (1) on the lower frame (2). Tighten the two positioning bolts (1-1)
first and other bolts next. Remove the tension pull cover (18). Attach the lower knife
cover (20) to the lower frame
(2) and the rear tension
pulley cover (18-1).
(Caution)
Tighten the upper and lower
frame joining bolts positively.
Otherwise, vibration may be
caused.
2 Assembly of table (see fig. 4
and 5.)
Mount the cutting table (3)
by aligning the tapped holes
of the table liners (3-1) with
the table fastening screw
holes (3-2). Fasten the table
(3) with the bolts (3-3). Slip
the blower hose (11-1) onto
the air mouthpiece (3-4) and
fasten the hose with a hose clamp. Attach the switch box (8) to the cutting table (3). Plug
the connector of the control cable (25) into the control panel (9) and fasten the plug with
the screw (25-1). (The screw is supplied by attaching it to the control panel.)
To Next Page
Loading...