Need help?Do you have a question about the OSHIMA OB-700 and is the answer not in the manual?
Wipe oil from the knife upon installation for rust prevention.
Remove tape from the driving pulley; part number NO.700A006.
Mount and secure the upper and lower frame components for stability.
Align and fasten the cutting table, including blower hose and switch box.
Install and tension the cutting knife onto the pulleys correctly.
Addresses error codes and motor stoppages related to the inverter.
General| Type | Overlock |
|---|---|
| Differential Feed Ratio | 0.7 - 2.0 |
| Presser Foot Lift | 5 mm |
| Stitch Length | 1 - 4 mm |
| Stitch Width | 5 - 7 mm |
To Next Page