What to do if my Oshkosh Corporation JLG E400Anarrow shows high engine temp?
If your Oshkosh Corporation Boom Lifts engine temperature is high, check for any obstructions that might be blocking the cooling airflow to the engine. Also, make sure the ambient temperature is within the engine's design limits. Finally, verify that the engine temperature sensor is working correctly.
What to do if Oshkosh Corporation JLG E400Anarrow unit is off or disabled and the engine will not crank?
If your Oshkosh Corporation Boom Lifts unit is off or disabled and the engine won't crank, check the position of the selector switch and ensure the inhibit run is released. Check the warning LED and address any faults before restarting the RBS. Verify the start battery voltage, check the control fuse, and inspect for loose wiring or connections.
What to do if my Oshkosh Corporation JLG E400Anarrow is overcranking?
If your Oshkosh Corporation Boom Lifts is overcranking, start by checking the fuel level and connections. Then, verify the operation of the fuel solenoid and fuel pump. Also, check the start battery voltage. If you see white smoke from the engine exhaust, it means fuel is entering the engine but it's not firing. If the ambient temperature is low, make sure the heater or glow plug is working.
Why does my Oshkosh Corporation JLG E400Anarrow Boom Lifts have low oil pressure?
If your Oshkosh Corporation Boom Lifts has low oil pressure, first check the oil level and the oil supply lines. Verify the correct operation of oil pressure switch with a test gauge.
What causes underspeed in Oshkosh Corporation JLG E400Anarrow Boom Lifts?
If your Oshkosh Corporation Boom Lifts is experiencing underspeed, ensure the engine has an adequate supply of fuel and combustion air. Check the air cleaner. Also, verify the setting of the governor lever and readjust it if needed.
What causes overspeed in Oshkosh Corporation JLG E400Anarrow Boom Lifts?
If your Oshkosh Corporation Boom Lifts is experiencing overspeed, verify the setting of the governor lever and readjust it if required.
How to troubleshoot engine starting system fault in Oshkosh Corporation Boom Lifts?
To troubleshoot an engine starting system fault in your Oshkosh Corporation Boom Lifts, check the engine start battery charging system for current output and inspect for a failed engine start battery.
What to do if my Oshkosh Corporation Boom Lifts shows overvoltage?
If your Oshkosh Corporation Boom Lifts is showing overvoltage, check the alternator output voltage.
What to do if my Oshkosh Corporation JLG E400Anarrow Boom Lifts has no speed signal?
If your Oshkosh Corporation Boom Lifts has no speed signal, check the wiring connections.
General| Fuel Type | Electric |
|---|---|
| Platform Height | 12.19 m |
| Machine Width | 1.22 m |
| Working Height | 46 ft (14.02 m) |
| Platform Capacity - Unrestricted | 500 lb (226.80 kg) |
To Next Page
