From the RF Settings Menu, select BLAST.
Decide whether you are changing the Blaster for all devices or just
one of the devices of the Osiris.
Select ALL to change the blaster settings to
ALL devices in the Osiris. Then, go to Step 4.
Select DEVIC to change the blaster settings to
just one of the devices in the Osiris. Then, go
to Step 3.
The display changes to a list of the names of your devices. If you have
two pages of devices, pressing either of the page buttons will display
the other page. Select the device you would like to change IR/RF set-
tings, then go to Step 4.
Select the new setting by pressing the desired button, then press SAVE
to save your new setting and return to the RF settings menu.
3736
The Osiris
1
2
4
3
Turn Blaster ON.
Turn Blaster OFF.
Save the new setting
Exit this Menu without changing
the BLAST settings
Select a device
Page
Buttons
display the
other page
of devices.
Pre-Programmed Code Tables
The Osiris’s Pre-Programmed code library is divided into categories (TV, VCR,
AUX, etc.). Each category actually includes many types of components. For
example, the VCR category includes TV/VCR combo units.
Within each category, the code numbers are listed in rows by brand
(Sony, Panasonic, B & K, etc.). Some brands have more than one three
digit code for you to try. Just circle the correct row and refer to it while
you setup (step-by-step instructions for using Pre-Programmed codes are
found on page 5).
TVs, Plasmas, Projectors and Monitors
Cable TV Descramblers/Tuners
DVD Players, TV/DVD Combos, TV/DVD/VCR
Combos, DVD Recorders, and Laser Disc Players
VCRs and TV/VCR Combos
Amps, Preamps and A/V Receivers
Satellite Receiver
CD Players and Changers
Digital Video Recorders (TiVo, Replay)
Tape Decks, Lighting Controls,
Custom Installation Products
Pages 38-40
Pages 40-42
Pages 42-44
Pages 45-47
Pages 47-49
Page 49-50
Pages 50-52
Page 52
Pages 52-54
TV
CABLE
DVD
VCR
AUDIO
SAT
CD
DVR
AUX
Universal Remote Control, Inc.
To Next Page
Loading...