EasyManuals Logo

OSP ASCEND II A2EB322 User Manual

OSP ASCEND II A2EB322
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
STEP 2
F
J4
A
B
B
C
C
STEP 3
STEP 2 Fasten Columns (B) to Side Supports (C) and Center Trunk (A) using eight Bolts (F). LOOSELY TIGHTEN BOLTS (F) USING
4MM ALLEN KEY (J4).
STEP 3 Run Handset (E) cable through hole below Center Trunk (A) and connect cable to Control Box, located in Center Trunk (A). Connect cables
from Columns (B) to Control Box in Center Trunk (A) as shown.
Extend the trunk to fit table size.
E
A
A2EB322 / A2EB222
ASCEND II HEIGHT ADJUSTABLE BASE
ASSEMBLY INSTRUCTIONS
Page 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OSP ASCEND II A2EB322 and is the answer not in the manual?

OSP ASCEND II A2EB322 Specifications

General IconGeneral
BrandOSP
ModelASCEND II A2EB322
CategoryIndoor Furnishing
LanguageEnglish