KAMBER / KRESTA SERIES
4
5 HARNESS FIT
+ The harness straps should wrap fully around the shoulders with no gaps
between the pack and back.
+ The padded part of the harness straps should end 1-2" / 2.5-5 cm
below the armpit. And the harness should have 1-2" / 2.5-5 cm of
webbing remaining.
3 TIGHTEN HARNESS
+ Tighten the shoulder harness straps to tension by pulling them down and
back.
4 TIGHTEN LOAD LIFTERS
+ Tighten the load lifters to tension by pulling them up and forward. This
will pull the pack close to the body to help stabilize the load.
1 POSITION THE PACK
+ Completely loosen the pack’s hipbelt, harness and load-lifter straps.
+ Load the pack with 10-20 lbs/4-9 kg of gear.
+ Put the pack on and make sure the hipbelt is centered and rests over the
hipbone. The hipbelt padding should sit halfway above and below the
hipbone.
2 BUCKLE HIPBELT
+ Buckle and evenly tighten the hipbelt using Osprey’s cross body ErgoPull.
+ The padding of the hipbelt should wrap around the hips with approximately
1-3" / 2.5-6 cm of webbing between the buckle and the hipbelt when
tightened.
FIT
6 STERNUM STRAP
+ Adjust the sternum strap to approximately 2"/5 cm
below the collarbone; buckle and tighten to tension.
KAMBER - MEN'S SIZING
42L / 32L / 22L
S/M 16-20" / 41-51 cm
M/L 19-23" / 48-58 cm
16L
O/S 18-22" / 46-56-43 cm
KRESTA - WOMEN'S SIZING
40L / 30L / 20L
WXS/S 13-17" / 33-43 cm
WS/M 16-20" / 41-51 cm
14L
O/S 15-19" / 38-48 cm
WOMEN'S-SPECIFIC FIT
+ Shorter torso length
+ Narrower, shorter harness with curves designed to accommodate most
women's necks, shoulders and chests
+ A hipbelt designed to wrap naturally around the curves of a woman's hips,
offering better load stabilization and support
HOW TO MEASURE YOUR TORSO FOR YOUR PACK
SIZING / FIT
To Next Page
Loading...
Need help?
General
