KAMBER / KRESTA SERIES
9
FEATURE DETAILS
1 Undo the upper and lower
webbing straps completely, place
the snowboard on the pack
and re-buckle the lower strap,
securing the snowboard to the
pack with the webbing running
under the lower boot binding.
Tension the strap.
HORIZONTAL SNOWBOARD CARRY
M -42L / 32L / 22L / 16L W -40L / 30L / 20L / 14L
Reinforced hipbelt wings allow you to carry your snowboard
between your back and the backpanel of the pack to prevent
damage from sharp edges.
1 Remove the pack and place it on the ground with the foam
backpanel surface facing up.
2 Slide your snowboard through the harness straps with the
base surface facing up (your bindings should face the ground)
until the middle of the snowboard lines up with the middle of
the pack’s backpanel.
3 Lift the pack from the ground, taking care to keep the
snowboard balanced so that it does not slip out of the
harness straps.
4 Put the pack on and buckle the hipbelt and sternum strap.
5 To reverse the process, remove your pack and set it on the
ground, take care to keep your snowboard balanced so that
it does not slip out from the harness straps, and slide the
snowboard out.
VERTICAL SNOWBOARD CARRY
M - 42L / 32L / 22L / 16L W - 40L / 30L / 20L / 14L
Dual upper and lower reinforced strap wings on the reinforced fabric front panel of the Kamber provide
stable vertical snowboard carry.
M - 42L / 32L / 16L W - 40L / 30L / 14L
2 Re-buckle the upper strap and tension the strap securing
the snowboard to the pack.
M - 22L W - 20L
2 Untuck the upper strap webbing from the tuckaway pocket
over the left shoulder of the pack's harness. Run the
webbing over the snowboard and buckle the strap into the
female buckle located over the right shoulder of the pack's
harness. Tension the strap securing the snowboard into
place.
For more information on this and other products, pack care, how to pack your pack,
our lifetime guarantee, or to contact Osprey customer service, visit osprey.com.
To Previous Page
Loading...
Need help?
General
