6
TECHNICAL INFORMATION
• Voltage/frequency : 120V~ 60Hz 550W
• Bowl capacity: 5.2 QT
• KB time: 5 Minutes (Never use this appliance constantly for more than 10
minutes!)
BEFORE FIRST USE
All parts of the stand mixer are to be thoroughly cleaned before being used for
the first time. (see section: Cleaning).
Take out t he required length of cable from the cable tidy on the base of the
blender and connect the appliance to the mains supply.
TRIAL USE
Turn the locking switch, then lift the machine arm.
Put the mixi ng bowl onto the base, and lock into position lining up the
arrowhead symbols.
10. Fix the splash cover onto the mixing blade, then lock the blade into the
machine
Turn the locking switch, then push the upper part of the machine down to locate
the arm into position, then turn the locking switch up to lock the arm solidly.
Plug-in the cord, and turn the switch slowly from speed”1” to speed ”8” ( every
speed try for a few seconds).
After the trial, turn the switch to speed “O FF”.
Turn the l ocking switch and lift the arm, then take apart the mixing blade from
the blade connector try again.
To Next Page
Loading...