OsteoSys SONOST 3000 - 3.3.3 Patient Measurement Procedure

User’s Manual (Confidential)
OsteoSys Co., Ltd.
Model Designation : SONOST 3000 DOC. No. : OT06-2R7124
34
3.3.3 Patient measurement procedure
Clean the surface of the Coupling
Pad with an alcohol pad and apply
sufficient gel to probes.
NOTE !
To remove debris from the
probe, clean the surface of
the probe with an alcohol pad
before use.
Clean both sides of patient’s heel
with an alcohol pad and apply gel.
Insert patient’s foot.
Let a patient move his foot up and
down just like this picture.
Start a measurement after
insertion and positioning of the
patient's foot. Ensure correct Foot
Positioner 1 or 2 is used depending
on the patient’s foot size.
NOTE !