User’s Manual (Confidential)
OsteoSys Co., Ltd.
Model Designation : SONOST 3000 DOC. No. : OT06-2R7124
81
4.2 Maintenance and repair
4.2.1 Cleaning
Turn off the power before cleaning the device.
After using the device, wash with Alcohol swap.
The device should be cleaned with a clean soft cloth
with water every day, because gel remains around the
probe or below the device. Specially, gel stained on the
balloons should be moved. After this procedure, clean
the stained area with a dry piece of cloth.
Probe endurance condition
Temperature range : -40℃~70℃
Humidity 0~90%
Atmospheric pressure : 50~106kPa
External force 0~1N
Make sure not to put water or detergent on the device
directly because it can cause fatal damage in the
electric circuit contained inside.
To Next Page
Loading...