User’s Manual (Confidential)
OsteoSys Co., Ltd.
Model Designation : SONOST 3000 DOC. No. : OT06-2R7124
85
G) Places exposed to direct sunlight or places where air is polluted due
to dirt, salt and sulfur.
H) Places where chemicals are kept or toxic gas is leaked.
I) Places where the AC power line voltage fluctuates heavily.
J) Places where the AC power line voltage fluctuates heavily while this
product is operating.
K) Places where there is a ventilation problem.
L) Do not lean, shake or rock the product during transportation.
M) Adjust frequency, voltage or current to the product.
N) The product is portable but make sure to put a brake on it when you
stop the product.
O) Ground the product by using ground wire.
P) Do not share the power outlet.
3) Check followings before using the product.
A) Whether power is off before putting a plug in the socket.
B) Whether the power supply line is suitable with that of the system
(AC 100~240 V)
C) Whether the system is fully grounded.
D) Whether all the connection parts(power and optional equipment) are
connected with the system properly.
2.3 Before Turning on Power
E) The product has been factory-set for optimum performance. Do not
attempt to adjust any preset controls or switches except for operation
as specified in this manual.
F) If you experience any trouble with the product, turn it off immediately
and contact OsteoSys or its authorized dealer for assistance.
G) Before electrically or mechanically connecting a third party devices to
SONOST 3000, contact OsteoSys or its authorized dealer for
instructions.
H) Do not operate the product improperly when you use it with other
products.
I) Make sure to check whether external parts of the device directly
touches the patient.
J) Make sure to check whether the products keep distances at least
20cm from walls.
To Next Page
Loading...
