English-8
PLACING THE PORTA-FILTER
a. Position porta-lter underneath the brew head, attach porta-lter by rst moving
retainer clip back.
b. Position handle so that the handle lines up with the open lock icon “ ” on the unit
and ts into the groove.
c. Then, slowly turn it to the right until the retention clip is aligned with the closed lock
symbol “ ” on the unit.
a. c.b.
PLACING THE CUP(S)
a. Pull out the height adjustment tray if you are using a small “demitasse” cup to brew
espresso.
b. Keep the height adjustment tray inside its compartment if you are using a larger cup to
brew cappuccino.
c. Keep the height adjustment tray inside its compartment if you are using a larger cup
to brew latte.
CAUTION: When brewing cappuccino or latte, please make sure to adjust the frothing
tube lever in order to position the froth milk dispensing tube to point inside
the cup to be used.
c.
b.
a.
TURNING THE UNIT ON
a. Make sure unit is plugged in.
b. Turn unit on “I”.
a.
b.
The 3 control panel lights will start blinking during heating and until the water reaches the
perfect temperature. Once these lights become solid, the unit is ready to use.
To Next Page
Loading...
