10 11
English
WARNING
BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
1. The battery must be removed from the appliance before it is scrapped.
2. The appliance must be disconnected from the supply mains when removing the battery.
3. The battery is to be recycled or disposed of safely.
4. For battery removal or maintenance please contact an Oster
TM
Authorized Service Center.
Disposal in E.U. countries
Do not dispose of the appliance with domestic refuse and do not throw them into fire or water. As part of the E.U.
Directive governing the disposal of electric and electronic appliances, the appliance is accepted free of charge by
local waste collection points or recycling centres. Correct disposal will ensure environment protection and prevent
a potential harmful impact on people and the environment.
Disposal in non-E.U. countries
Please dispose of the appliance at the end of service life in an environmentally friendly manner, per applicable
local and national laws and regulations.
In the case the appliance does not operate but is under warranty, return the product to the place it was purchased
for a replacement. Please be aware that a valid form of proof of purchase will be required. For additional support,
please contact our Consumer Service Department at: + 49 (0) 6190-93443-0. International rates may apply.
Alternatively, e-mail: info@oster-europe.com.
WASTE DISPOSAL
AFTER SALES AND REPLACEMENT PARTS
TROUBLE SHOOTING
MALFUNCTION CAUSE RECTIFICATION
Top blade does not move Clipper-head is not well engaged Engage the clipper-head correctly when the
motor is running
Drive carrier is defective Replace drive carrier (*)
Clipper cuts badly or not
at all
Clipper blade is blunt Have top and bottom blades re-sharpened by
Oster
TM
authorized service center
Clipper Blades have not been
correctly grounded
Clipper blades are not oiled Oil clipper blades every 15 minutes
Hairs jammed between top and
bottom blades
Take off clipper-head, push the top blade half
away from the clipper head, take away hairs
between top and bottom blade
Clipper-head has too little clipping
pressure
Have clipper-head inspected (*)
Motor is not running Battery is not charged Charge battery
Contacts dirty Switch clipper «OFF» (O) and clean the
contacts
Faulty battery Replace battery (*)
Smell of burning from the motor
housing. Motor burned out
Have motor and / or electronics replaced (*)
Motor and / or electronics faulty Have motor and / or electronics replaced (*)
Clipper-head blocked Clean and oil clipper-head
Motor runs very slowly Clipper blades were not oiled
sufficiently
Oil clipper blades
Running time of a fully
charged battery is too
short and / or blades are
getting hot
Clipper blades were not oiled
sufficiently
Oil clipper blades
Battery is not fully charged, or
faulty battery is being used
Only use intact, fully charged original batteries
When battery is
unloaded the light does
not change from green
to red
Contacts dirty Clean contacts
Faulty battery Replace battery (*)
Contacts of the charging station are
deformed
Have the charging station repaired (*)
English
The tasks described here for troubleshooting can be done mostly by the operator.
Some tasks only may be done by specially trained personnel or by an Oster
TM
authorized service center. These
tasks are marked with (*).
076076CL_078005CL_076076-810-050_078005210-050_21MLM2 (EMEA).indd 10-11076076CL_078005CL_076076-810-050_078005210-050_21MLM2 (EMEA).indd 10-11 2021/10/29 下午4:592021/10/29 下午4:59
To Next Page
Loading...
Need help?
General
