29
Finishing Problems and Remedies
Problem: The granulate is very wet.
Cause: The polishing paste dose was too high.
Remedy: Take the granulate out of the machine and let it dry in the air for a
few days. Use fresh granulate in the meantime.
Problem: The granulate is very dry – it is dusty.
Cause: The polishing paste dose was too low.
Remedy: Add 2 – 3 cm polishing paste P 6 from the tube into the cold granule.
Mechanical Malfunctions
and Remedies
Problem: The machine is making “squeaking” noises.
Cause: Work pieces can have worked their way underneath the disc.
Remedy: Remove the disc. Loosen the screw in the centre with a size 3 Allan
key. Remove the pieces underneath the disc, put 2 teaspoon fine
granule under the disc, and refasten disc on reverse sequence.
Problem: The disc blocks.
Cause: The disc is either strongly worn along the outside edge or work
pieces have worked their way underneath the disc.
Remedy: Examine the disc for intense wear and replace it, if necessary.
E
To Next Page
Loading...