24
Finishing examples for dry polishing
● Finishing of emerypaper-treated jewelry
If you want to avoid wet or dry grinding you should treat jewelry or
chains with sandpaper (minimum 600 grain size sandpaper) first.
Fill 1.5 litre of HN1/100 (coarse walnut-shell granule) into the process-
container. Set the finishing time by turning the timer in a clockwise
direction. The machine starts automatically. Finishing can take up to
15 hours depending on the surface.
Now use the fine walnut-shell granule (HN1/500) for approximately
30 minutes.
If want to decrease your process times, we recommend to wet grind
the jewellery before in an ECO-wet.
● Finishing jewlery with fine scratches
Fill 1.5 litres of HN1/100 (coarse walnut-shell granule) into the process-
container. Set the finishing time by turning the timer in a clockwise
direction. The machine starts automatically. Finishing time: 1-3 hours.
Now use the fine walnut-shell granule (HN1/500) for approximately
30 minutes.
● Finishing dull jewlery
Fill 1.5 litres HN1/500 (fine walnut-shell granule) into the process-
container. Set the finishing time by turning the timer in a clockwise
direction. The machine starts automatically.
Finishing time: approx. 30 minutes. The machine switches itself off
automatically after the time set has expired.
Finishing Process
To Next Page
Loading...