OTT-JAKOB Power-Check 2 - Page 24

PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
6 SYSTEM SETTINGS
The Power-Check 2 allows to change the following settings:
Identification number ID
Activation threshold value for the motion detector (in automatic operation)
Measuring duration in automatic mode
Display brightness
Follow the following steps for changing values:
Select configuration
menu
clear
off
manual
auto
push 3 second
StA and then con : release buttons
LED config lights up
IIt is possible to adjust various values in the configuration menu. The
same pattern applies to every setting:
increase value
clear
off
press briefly
decrease value
manual
auto
press briefly
next setting in
configuration menu
clear
off
push 1 second
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 24