PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
5.4.2 Measured value memory
The measured pull-force is stored internally and can be logged with an adequate reading device
(USB interface). Handling is described in a separate document.
Many thousand measurements can be stored.
The display message
f u l
indicates that the measured value memory is at 100% capacity.
Additional measured values will overwrite the first measured values!
5.5 MEASURING RANGE
Do not exceed the maximum measuring range: damage of the measurement system!
Values above the maximum measuring range are indicated by flashing lights.
Only values within the measuring range can be stored.
5.6 BATTERY STATE OF CHARGE
The battery condition is briefly displayed during power on
(Bar display 0 - 100%).
If the LED bat low (battery low) lights up, the measurement
system has to be recharged at the USB interface as soon as
possible. → 4.2
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 23
To Next Page
Loading...