PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
7 MAINTENANCE
7.1 SPARE PART
designation order-no.
O-ring 35,5 x 1 0.926010.237
cap 95.106.132.3.1
7.2 DEACTIVATION IN THE EVENT OF FAILURES
The device can be forced to deactivate in the event of failures. For this: Dazu:
Remove cap
Touch the deactivation contact with a
magnet
The system is now deactivated can be switched back on. The stored measured values remain
preserved.
7.3 MAINTENANCE
Inspection by OTT-JAKOB
yearly
after a fall or a similar incident
7.4 DEACTIVATION
After deactivation, proper battery disposal requires the measuring unit to be shipped to OTT-JAKOB.
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 26
To Next Page
Loading...