PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
8 PC SOFTWARE
8.1 PRODUCT DESCRIPTION
The software allows adjusting system parameters and reading and exporting measured values stored in
the system.
The software contains the driver for charging the pull force measurement system Power-Check 2
battery.
8.2 INSTALLATION
System requirements:
USB interface
Windows operating system
(tested with Windows 2000, Windows XP and Windows 7 32 bit-version)
CD drive for installation
The measuring system must not be connected during installation!
Insert CD
Start .exe file
Installation begins, the following information is requested:
Language
Program storage location
Installation is closed after accepting the license agreement.
Note for uninstallation: Program may be uninstalled using the supplied program „Power-Check
II_remove“.
At the first connection of the measurement equipment with the Windows PC, the device detection is
done by Windows.
connect the Power-Check II via the supplied USB cable with the operating PC
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 27
To Next Page
Loading...