PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
8.3 OPERATION
8.3.1 Start-up
Connect Power-Check II to the active PC via the supplied USB connection cable.
Wait for system recognition by the operating system
Start program Power-Check II - PC software; the following should be displayed in the connection
display:
1 device(s) found and 1 connected
Observing the sequence is essential!
8.3.2 Display and operation
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 28
To Next Page
Loading...