PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
Display area
The green display area indicates displays the following information:
Connection: successful when
1 device(s) found and 1 connected
appears
Inspection date: date of OTT-JAKOB outgoing inspection (regular inspection)
System serial number
Firmware version number
Category settings:
Read Config: Pressing this button reads the current measuring system settings; these settings
are displayed during startup as described above
Write Config: Pressing this button transfers the program field setting changes to the measuring
system, overwriting the previous settings.
Set default: Pressing this button resets all program values to factory default.
System setting for ID, Interrupt, Duration and Brightness: May be altered by pressing the arrow-up-
button or arrow-down-button or by adding a value. → 6 / 24
Settings for time and date are take over from the PC; no possibility to adjust from within the
program.
Sleeve position is displayed only, no possibility to adjust from within the program. → 4.1 / 17
Continuous measuring mode settings are altered via the same method as the system settings.
→ 5.3 / 21
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 29
To Next Page
Loading...