11
DRY mode:
When you select DRY mode, the appliance is in dehumidifying mode and works at its lowest speed. In this
mode, the fan speed can’t be changed..
FAN mode:
When you select FAN mode, only the fan is operating. There is no heating, nor cooling in this mode.
HEAT mode:
When you select HEAT mode, device is working on heating mode. Press the " + " or " - " button to adjust
temperature.
NOTE:
• In HEAT mode, the device will delay start-up of the fan to prevent cool air to circulate. This delay can
take up to 5 minutes depending on indoor air temperature.
4. FAN button
Push this button to select the fan speed along this sequence:
Automatic (AUTO), low (
), medium-low ( ), medium ( ),
medium-high ( ), high ).
NOTES:
• On AUTO speed, the device will choose ideal speed according to room temperature and set tempera-
ture.
• In DRY mode (dehumidification), fan always goes at low speed.
5. SWING button
Press this button to select oscillating angles for the louvres as per following sequence:
• When selecting " ", horizontal louvre will automatically flip upward and downward at a maximum
angle.
• When selecting "
, , , , ", the device blows air at fixed position. Horizontal louvre will stop
to the chosen position.
• When selecting "
, , ", device blows at fixed position. Horizontal louvre will be at fixed angle.
• Hold the SWING button for 2 seconds to define required oscillating angle. When reached, release the
button.
NOTE:
"
, , " may not be available. When device receives this signal, it will function as per following
position " ".
To Next Page
Loading...
