OUMAN EH-201/L User Manual

OUMAN EH-203OUMAN EH-203OUMAN EH-201/LOUMAN EH-201/L
Press the button to move cursor to "Clock functions”. Press OK.
Clock programs - browsing, adding, deleting
19:30
00:00
_______
DropOnH1
Drop Off
MoTuWeThFr_ _
19:30
_______
DropOnH1
MoTuWeThFr_ _
Drop Off04:30
19:30
_____ __
00:00
_______
DropOnH1
Drop Off
Clock functions
Time/ Date
H1 drop program
R1 Time program
R2 Control
MoTuWeThFr_ _
04:30
00:00
_______
00:00
_______
etc.
Drop Off
DropOnH1
Drop Off
MoTuWeThFr _ _
Press the button to move cursor to the program (H1 drop program or
relay control programs) whose time controls you want to access
(browse, add or delete). Press OK.
Set the start time for the temperature drop program: OK.
OK.
OK.
-+
-+
Press
Temperature drop start time hours blink.
the or button to set hours. Press
Minutes blink. the or button to set minutes. Press
Press
Press
Set the weekdays (when the start time is effective):
OK
OK.
-+
-
Press the or button to select weekday.
The day is left unselected / press the -button to delete the selection.
The selection shown on the display is taken into use with the button.
Make your selection for each day and press
Set the end time for the temperature drop program: OK.
OK.
OK.
-+
-+
Press
Hours blink. the or button to set hours. Press
Minutes blink. the or button to set minutes. Press
Press
Press
Set the weekdays (when the end time is effective):
OK
OK.
+
-
Press the button to select weekday.
The day is left unselected/ press the to delete the selection.
The selection shown on the display is taken into use with the button.
Make your selection for each day and press
19:30
_____ __
04:30
_______
DropOnH1
Drop Off
Browse/ location for additional programming:
the button to browse the clock programs which have been
made. If you want to make additional programs, move cursor to first
empty program block.
Press
H1 Select
Heating curve
Settings
Measurements
Info water temp
Control modes
Clock functions
Language/Keel
Press ESC until the display no longer changes.
You are then in the "Selection" display shown in the adjoining picture.
OPERATING INSTRUCTION:
Press
OK.
You can delete the program block inside the brackets by deleting the
weekdays in that program block with the button.
DELETING THE PROGRAM BLOCK:
-
1. Drop the temperature for certain lengths of time
2. Time control the desired on/off connections with two relays (eg.
ventilator, outdoor lights, sauna stove, outside doors, see p. 24-26).
With the freely programmable 24 hour/7 day clock you can:
There is always one program block inside the brackets (drop on and off).
The cursor moves to the beginning of the next program block (new brackets).
Continue programming as before or exit with
In the example the drop is in effect during the workweek between 19:30
and 4:30. On the weekend the drop begins on Friday evening at 19:30
and ends on Monday morning at 4:30.
ESC.
H1
Outdoor °C
SupplyTemp °C
Selection
Automatic
-15
52
ESC - press to return to the previous display
Info button - gives operating instructions
Browse button - moves the cursor up and down
ESC
Group select button - not in use in EH201/L
14

OUMAN EH-201/L Specifications

General

Brand	OUMAN
Model	EH-201/L
Category	Controller
Language	English