Outback S-Lite User Guide 10 PN 875-0194-000 Rev D1
Chapter 2: Getting Started
Before using S-Lite for the first time, complete the following tasks:
• Installing S-Lite
• Powering S-Lite
• Configuring S-Lite
Installing S-Lite
Correct installation of S-Lite is critical for safe and correct operation. Correct
installation includes determining the location to install components as well as the
actual installation of them and the routing of associated cabling. Components that you
need to correctly locate, install, and route are the antenna, the console, the antenna
cable, and the power cable.
Mounting the Antenna
Make sure to install the antenna in a location that will optimize its performance. It
should be centered (left and right) on the vehicle as high and as far forward as
possible, usually along the leading edge of the vehicle cab. Do not place the antenna
within 2 feet of a transmitting radio antenna (such as a 2-way or business band radio).
1. Clean and dry the surface where the antenna mounting plate will be
attached.
2. Remove the paper backing from one
side of the adhesive disk and attach
to the back of the antenna mounting
plate.
3. Remove the paper backing from the
other side of the adhesive on the
mounting plate.
4. Position the mounting plate and
press down hard for good adhesion.
5. Place the magnetic mounted
antenna on the plate and be sure it
is on the exact centerline of the
vehicle.
SLite_UG_D1.book Page 10 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...