Outback S-Lite User Guide 11 PN 875-0194-000 Rev D1
Chapter 2: Getting Started
Mounting the Console
Normally, you mount the S-Lite console above and behind the center of the steering
wheel just below the driver's line of sight. The easiest installation is on the front glass
of the cab. If this is not possible, you can vacuum mount the assembly to any non-
porous (metal) surface.
To mount the console:
1. Attach the RAM ball mount securely to the back
of the S-Lite console.
2. Install the RAM pedestal to the vacuum cup
using the two self-tapping screws provided.
Tighten the screws securely.
3. Attach the RAM pedestal to the RAM ball on the
back of the S-Lite console.
4. Thoroughly clean the inside cab window surface directly in front of the
steering wheel.
5. Press the vacuum mount to the
window and twist the actuator
until it clicks over center to create
adhesion to the glass.
6. Loosen the RAM mount and adjust
the console to the proper viewing
angle.
Note: Do not leave the console unattended for extended periods of time. If possible,
remove the console from the glass when it is not in use. Continued exposure to the
elements (such as direct sunlight) may damage the suction cup. To extend the life of
the suction cup clean it periodically per manufacturers instructions.
SLite_UG_D1.book Page 11 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...