Outback S-Lite User Guide 12 PN 875-0194-000 Rev D1
Chapter 2: Getting Started
Routing the Antenna Cable
Always power off the console before attaching or removing cables.
1. Route the cable to a cab opening where
rubber protection exists that will protect
the cable (a closed window works fine).
2. Attach the end of the cable to the console.
3. Coil excess cable in a protected location and secure the installation with tie
straps.
Powering S-Lite
There are two methods of providing power for S-Lite:
• You can connect the standard
power cable directly to a
compatible rate controller
speed sensor port.
• You can attach the provided CLA
adapter to power S-Lite from a
12 VDC power port. The standard
power cable supplied with the
S-Lite is compatible with rate
controllers that require a Dickey
John speed sensor connection.
An optional cable is available
from Outback Guidance to allow
connection to rate controllers
that require a Raven speed
sensor connection.
Note: Do not bend the cable to a radius
of less than 6 inches. Avoid routing it
within 12 inches of radio wires, power
generator wires, a heat source, or
moving parts.
Rate controller front
Rate controller back
SLite_UG_D1.book Page 12 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...