Outback S-Lite User Guide 13 PN 875-0194-000 Rev D1
Chapter 2: Getting Started
To p ow er S -L it e:
1. Connect the power cable to the
console at the PWR/GSI port.
2. Twist the connector firmly until it
snaps into place.
3. Connect the power cable to the
power supply, either from your rate
controller or 12 VDC power port.
4. Coil excess cable in a protected
location and secure the installation
with tie straps.
5. Toggle the power switch located on the right end of the console. S-Lite will
complete an LED self test after which the RED LED illuminates indicating No
Signal.
S-Lite automatically begins acquiring a DGPS signal. This process may take
a few minutes. During this process, the vehicle can be moving or the
operator can perform menu functions. Upon achieving a GPS signal, the
YELLOW LED illuminates. Finally, once S-Lite has acquired a DGPS
correction signal, the GREEN LED illuminates. The GREEN DGPS LED must
be illuminated for S-Lite to provide guidance.
Note: Cigarette lighter sockets may provide intermittent power. For
permanent installations, Outback Guidance recommends removing the
cigarette lighter plug and hard-wiring the leads to a reliable 12 V power
supply.
Note: The antenna must have a clear view of the sky to acquire a DGPS
signal.
No Signal
DGPS
GPS
Power switch
SLite_UG_D1.book Page 13 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...