Outback Guidance Series - Guidance Overview

Outback S-Lite User Guide 14 PN 875-0194-000 Rev D1
Chapter 2: Getting Started
Configuring S-Lite
You configure S-Lite by setting various values in the Setup menu and Service menu.
Using the Menu
1. To access the menu, press the MENU button.
2. Select an item by using the UP ARROW and DOWN
ARROW buttons. The “>” character points to the active
menu item.
3. Press the ENTER button to select.
Setup Menu
Menu Item Display Sequence Default Description
Brightness Brightness
> 5
[1 to 10]
Default = 5
Adjusts the display
brightness. 1 is dim, 10 is
bright. The LEDs also
brighten or dim as you
adjust this setting.
Swath Width Swath Width
> 30.00 ft
[3.4 ft to 3280.67 ft]
Default = 30.00 ft
Adjust this number to
equal the width of the
implement or boom.
Sensitivity Sensitivity
>Medium
[Low, Medium, High]
Default = Medium
Adjust the manual
guidance indicator
sensitivity to LOW,
MEDIUM, or HIGH.
Perimeter
Setup
Perimeter Setup
>Right
[Left, Center, Right]
Default = Right
Select RIGHT, CENTER, or
LEFT edge of swath width
for field perimeter area
calculation (see
“Calculating the Area of a
Field” on page 24).
Diagnostics See “Diagnostics” on page 34.
Service Menu See“Service Menu” on page 15.
6HWXS0HQX
%ULJKWQHVV 
6ZDWK:LGWK 
6HQVLWLYLW\ 0HGLXP
3HULPHWHU6HWXS 5LJKW
'LDJQRVWLFV !
6HUYLFH0HQX !
SLite_UG_D1.book Page 14 Monday, December 23, 2013 2:14 PM