Outback S-Lite User Guide 21 PN 875-0194-000 Rev D1
Chapter 3: Using Guidance Features
Using Straight Guidance
The first pass can either be established along a straight side of the field, or it can
divide the field with a straight swath working out each side. Either way, all passes will
be perfectly and uniformly spaced across the field.
Setting the A=B Line
The A=B line is an imaginary line that passes
through two points to define the first pass. All other
passes are perfectly spaced on both sides of the
first pass.
Marking Point A and Point B While Driving
1. Position the vehicle at the beginning of the first pass.
2. Press the STRAIGHT GUDANCE button.
3. Select SET NEW AB on the display screen and press
the ENTER button.
4. Press the ENTER button to mark Point A.
5. Drive the first pass.
6. At the end of the pass, press the ENTER button to
mark Point B.
Begin Straight Guidance
After setting the A=B line, S-Lite automatically begins guiding.
1. Turn the steering wheel in the direction indicated
by the Steering Guide lights to remain centered on
the current pass.
2. At the end of the current pass, turn around. S-Lite
automatically detects the next pass and begins
guiding.
SLite_UG_D1.book Page 21 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...