Outback S-Lite User Guide 23 PN 875-0194-000 Rev D1
Chapter 3: Using Guidance Features
Using Contour Guidance
Select Contour Guidance to follow previous passes. In this mode, the
S-Lite is either logging an initial pass or guiding from a previous pass.
After selecting Contour guidance, proceed by making the initial pass
without using the Steering Guide lights. Later, when attempting to follow a
previous pass, the guidance will engage. You generally use Contour
Guidance for working out borders, turn areas and contour following.
1. Press CONTOUR GUIDANCE before beginning the
initial pass. The display shows “LOGGING PASS”.
2. Make the initial pass without using the Steering
Guide.
3. At the end of the current pass, turn around and begin
the next pass. S-Lite automatically detects the previous pass and begins
guiding.
Guiding on Subsequent Passes
Anytime the vehicle is within half a swath width of a previously logged pass, the S-Lite
automatically begins to guide. In Contour mode, S-Lite can guide from any previous
pass, even those made in Straight guidance mode.
Making A New First Pass
Occasionally a situation arises in the middle of a job when a pass will need to be made
that follows a different path than the previous passes. Simply drive the new path.
Once it becomes obvious that a new pass is being defined, S-Lite goes into logging
pass mode. Subsequent passes are guided from this newly defined pass.
SLite_UG_D1.book Page 23 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...