Outback S-Lite User Guide 24 PN 875-0194-000 Rev D1
Chapter 3: Using Guidance Features
Calculating the Area of a Field
At the beginning of each new field, you can use S-Lite to calculate the field perimeter
area of the first contour pass around the field.
1. Press STOP GUIDANCE.
2. Press the DOWN ARROW button.
3. Select ERASE MEMORY from the display screen.
4. Press the ENTER button.
5. Press the MENU button.
6. Select PERIMETER SETUP from the display screen.
7. Press the ENTER button.
8. Select RIGHT, LEFT, or CENTER, to set which swath
width position will be used to calculate the perimeter.
9. Press the ENTER button.
10. Press the CONTOUR GUIDANCE button.
11. Drive the vehicle around the outside edge of the field.
The main guidance screen displays “LOGGING PASS”.
12. Press the DOWN ARROW button to display the
perimeter area calculations. The displayed AREA-”x”
shows the current perimeter setup selection where
“x” is L=left, C=center, or R=right.
The calculations continuously update until the vehicle is within one swath width of the
starting point. S-Lite then automatically closes the perimeter and displays the final
calculations.
Note: The units for the area calculation are Acres if the unit of measure is set to Feet,
and Hectares if the unit of measure is set to Meters.
SLite_UG_D1.book Page 24 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...