EasyManuals Logo

Outbound XP1010ST-1 User Manual

Outbound XP1010ST-1
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
KEY
NO.
MODEL NO. XP1010ST-1(076-5464-6)
QTY.
REQ
DESCRIPTION
1
8
HTFXP1010ST-1
HMS5-8
Canopy
1
HTDXP1010ST-1
Detachable Wind Wall
Stakes
PART NO.
REPLACEMENT PARTS
SPECIFICATIONS: Shade size: 10’ x 10’ (3.05x3.05m)
Centre height: 110” (2.79m)
Weight: 37.35lbs (16.94kg)
Call customer service for steel frame replacement parts.
TROUBLESHOOTING GUIDE
PROBLEM
1. CONDENSATION
2. SEAM LEAKAGE
3. MILDEW
4. REPAIRING A TEAR
5. FAULTY ZIPPER
6. FADING FABRIC
7. FLOOR CONDENSATION
Condensation occurs when warm moist air inside tent comes in contact with cooler outside air. Avoid touching walls to reduce contact leakage. Venting doors and
windows will reduce condensation. Store wet clothing outside of tent. A battery powered fan may be helpful. Not applicable to screen houses.
Apply a generous amount of seam sealer on inside seams. Seam sealer may be purchased at any local sporting goods store.
To avoid mildew, store tent/screen house ONLY when thoroughly dry. However, if mildew occurs, use a soft bristle brush or sponge with mild dishwashing soap or Fels
Naptha soap to clean. Let dry thoroughly, and a tent approved water repellent compound may be applied.
For small tears, use a self-adhesive patch kit. We recommend a canvas or awning repair shop for larger tears.
Zippers are self-repairing. If the zipper separates, you can move the slider to the beginning of the zipper tape and rework the zipper.
Do not leave up in direct sunlight longer than necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.
8. USE OF STAKES
Stakes should be installed at a
45° angle using a hammer or mallet. Stake loops should be kept taut without over-stretching fabric or webbing. This could cause tears or
leakage. To remove safely, use a hammer or stake puller. Do not remove by pulling on the fabric.
SOLUTION
A ground cloth under the floor helps prolong its life, provides additional insulation and moisture protection. The cloth should be smaller than the floor to prevent rain
from running under the tent. Not applicable to screen houses.
XP1010ST-1 05/15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Outbound XP1010ST-1 and is the answer not in the manual?

Outbound XP1010ST-1 Specifications

General IconGeneral
BrandOutbound
ModelXP1010ST-1
CategoryTent
LanguageEnglish

Related product manuals