You will also use OFF mode if you connect the
camera to a computer’s USB port later.
c. ON mode
Anytime after the batteries and SD card have
been inserted, you can switch on the camera.
When the power switch is moved to the ON
position, the camera will enter into the ON
(Live) mode. The motion indicator LED (Fig 3)
will blink red for about 10 seconds. This interval
allows time for you to close the Outdooree
R6’s front cover, lock it, and leave the
monitored area. Once in the ON mode, no
manual controls are needed or possible. The
Outdooree R6 will take photos or videos
automatically (according to its current
parameter settings) when it is triggered by the
PIR sensor’s detection of activity in the area it
covers.
13
To Next Page
Loading...