7. Switching ON the Camera
Once you switch to the
ON
mode, the motion
indicator LED (red) (Fig 3) will blink for about
10 seconds. This gives you time to close and
lock the front cover of the
Outdooree R6
and
then walk away. During this time, the motion
indicator LED will blink red continuously. After
it stops blinking, the PIR is active, and any
motion that is detected by it will trigger the
capture of photos or videos
as programmed
in the
SETUP
Menu.
8. PLAYING BACK/DELETING the
PHOTOS/VIDEOS
After you have setup, mounted and activated
your Outdooree R6, you will of course be
eager to return later and review the images it
has captured for you.
a. Reviewing Images on an
External Video Monitor
25
To Next Page
Loading...