OutdoorMaster SHARK - Fault Handling; Maintenance and Storage

IX. Maintenance and Storage
VIII. Fault Handling
Fault Inspection Solution
The air pump
cannot be
started
normally.
1. The power source is
not plugged properly.
2. The fuse in DC plug
is burnt out.
3. Overheating or
overload causes motor
stop.
1. Check whether the
hose is blocked or
cracked.
2. The joint between
the hose and air pump
or air bag is not
installed properly.
1
. e that the r
plugged in the 12V DC socke
2. Change the fuse.
3. Cool the motor and re tart
it.
4. If the problem cannot be so
lved,
please contact local service age
nts or
similar authorized personnel
to change
the product.
unblocked, and check whethe
r the hose
is cracked.
2. Reinstall the hose.
3. If the problem cannot be so
lved,
please contact local service age
nts or
similar authorized personnel
to change
the product.
Slow or
abnormal
inflation or
deflation.
1. Make sure that the power wire is plugged
in the 12V DC socket.
2. Change the fuse.
3. Cool the motor and restart it.
4. If the problem cannot be solved, please a
contact us for further assistance. Please
see our contact info at the end of this
manual.
1. Change the hose or remove anything
blocking it and make sure it’s not cracked.
2. Reinstall the hose.
3. If the problem cannot be solved. Please
see our contact info at the end of this
manual.
* After use, or if you want to move or adjust the product, please start with
unplugging the DC plug from the socket.
* When the power is connected the cooling system will automatically be
on. If the air pump is idle for 10 minutes the cooling system will automati-
cally switch off until inflation is started.
* In order to extend the life of the pump, we recommend keeping the
power on for at least 3 minutes after inflating your ISUP, to make sure the
motor cools down properly.
* Please store it in the dry and ventilated place.
In case of over heating:
1.Check the air hose for leaks. Also make sure that the air hose is
properly connected to the pump interface and the SUP to prevent air
from leaking during the inflation process.
2.If the pump shuts down due to overheating, please restart it and keep
it on for a few minutes without inflating. That will let the Active Cooling
System cool down the motors to operating temperature.
OP20 DC12V ELECTRIC AIR PUMP
6