V. Inflation Operation
* Install one of the air taps (10) or one of the valves - H3 (12) or C7 (13)
- on the hose based on your inflatable's air inlet valve. If you are using the
H3 or C7 valve make sure to put on of the plastic gaskets (11) on the
valve for an airtight seal. Choose the plastic gasket with a thickness that
suits your SUP.
* Connect the hose (9) to the air pump inflation inlet (1), and then turn
clockwise to tighten it, as Figure 1.
* Connect the hose end with the air tap to your inflatable’s air inlet valve
(step 1 in Figure 2). If you are using the H3 air tap also twist clockwise to
tighten and lock it in place (step 2 in Figure 2).
* Plug the DC plug into your car’s 12V car connector.
* Press the pressure unit toggle button to select the unit you need.
3
OP20 DC12V ELECTRIC AIR PUMP
- Don’t disconnect the pump with wet hands.
- This product shall not be exposed to rain or immersed in water.
- In order to avoid risk of injury, the inflation inlet shall not be faced
towards face or body.
- This product is not to be used by a person with declining physical
strength, sensory ability or mental capacity, any person lacking the
necessary skill or someone with mental disability, unless they are under
the protection of their guardians, supervised and directed during opera-
tion.
- Do not bury the wire in the ground. It shall always be placed in a safe
zone where it won't be damaged by mower or other equipment.
If you are standing in a place with water or your hands are wet, don't plug
in or unplug the pump from its power source.
- Before using, please check the cigarette lighter socket to make sure that
there is no rust or residue inside. A cigarette lighter socket with poor
electric conduction may cause the product to overheat, which will
damage the product.
- The purpose of using this product is limited to the description in this
instruction book.
To Next Page
Loading...
