Need help?Do you have a question about the Overhead door RMX DRAWBAR and is the answer not in the manual?
General| Brand | Overhead door |
|---|---|
| Model | RMX DRAWBAR |
| Category | Door Opening System |
| Language | English |
Provides safety terminology and instructions for operation.
Details pre-installation concerns and decisions for operators.
Step-by-step instructions for installing and setting up the operator.
Details operator features and troubleshooting information.
Covers service, maintenance, drawings, and warranty policy.
Details potential hazards like moving doors, electrical shock, and spring tension.
Key safety points for door operation and essential maintenance checks.
Lists items to consider before selecting an operator for a job site.
Recommends fail-safe external reversing devices for enhanced safety.
Details the components of the drawbar operator assembly.
Continues instructions for attaching drawbar track and related components.
Instructions for attaching chain guide assemblies to the drawbar tracks.
Instructions for routing and tensioning the drawbar chain correctly.
Instructions for preparing and marking the header for operator installation.
Instructions for positioning and temporarily suspending the operator unit.
Instructions for securely attaching the operator to the header and superstructure.
Instructions for connecting the drawbar arm to the door bracket.
Details how to adjust the clutch and brake for proper operator function.
Instructions for connecting the main power supply to the operator.
Instructions for routing low voltage control circuit wires to the operator.
Shows wiring connections for various controls and safety devices.
Connects wall controls; warns about momentary contact safety.
Explains use and wiring of interlock switches for specific door types.
Instructions for radio control and photocell installations.
Instructions for installing a sensing edge switch for safety.
Overview of the control panel, its keys, and operating modes.
How to set open/close modes to constant contact for operation.
Procedures for setting the door's open and close travel limits.
How to adjust the limit overrun for proper door seal against the floor.
Instructions to activate monitored photocells in calibration mode.
Explains the Max Run Timer feature and how to reset it.
How to set a programmable mid-stop point for door opening.
How to set OPEN/CLOSE modes to Momentary Contact for operation.
How to view the operator's cycle count.
How to view the firmware version number of the control board.
How to set the GDO configuration type (Jackshaft/Trolley).
How the operator display indicates status and errors.
How the operator stores and displays error codes for diagnostics.
How to access and view the error code memory.
How the operator stores and displays run codes for diagnostics.
How to access and view the run code memory with an example.
Explains the diagnostic LED indicators on the circuit board.
Recommended service and maintenance intervals for the operator.
Illustrated breakdown of the operator's main components.
List of parts for the operator assembly with part numbers.
Exploded views of the output and intermediate shaft assemblies.
Lists parts for the output and intermediate shaft assemblies.
Illustrated breakdown of the rail and trolley components.
Lists parts for the rail and trolley assemblies.
Illustrated breakdown of the electric box components.
Lists parts for the electric box assembly.
Continues the list of parts for the electric box assembly.
Details functions and connection types for terminal assignments.
Lists condition codes and their descriptions for operator status.
Lists error codes and their descriptions for troubleshooting.
Continues the list of error codes and their descriptions.
Troubleshooting chart for monitored photocells.
Details the operator's warranty terms and conditions.
To Next Page