EN
Control mode
The drone has two control modes which change position of left and right
bar. By default, mode 2 is set (see: fig. 16).
A – Fly forward or backward
B – Turn left or right
C – Choke valve
D – Fly left or right
To change the mode:
1. Press the lock key (6) and then activate the controller by sliding
the on/o key (see: fig. 17).
2. Press and hold the return key for about 3 seconds to select mode 1
or 2. The selected mode is displayed on the LCD screen (G). Press and
hold the key to change the mode.
By default, the product operates in mode 2
How to calibrate the gyroscope
After connecting to the remote control, place the drone on a flat and
horizontal surface and then direct both bars on the remote control into the
bottom left corner (fig. 18). When LEDs stop flashing in green, it means the
calibration has been finished.
Note: the drone has already been calibrated. There is no need to re-calibrate
it unless the drone has diculty in taking o or completing the detection
procedure.
Detection mode
After connecting to the remote control, the drone starts detecting. Front
and rear LEDs of the drone start flashing alternately in red, green and yellow.
Make sure the drone stands on the flat and horizontal surface at this time.
To Next Page
Loading...
