EQUALIZER
INSERT switch - Engages the external insert send and return, which is after the compressor
and before the DRIVE. The send is always active, and return is enabled with the switch. If no
signal is present at the return XLR with the INSERT switch engaged, the SAT feed will
have no output and appear muted.
300Hz/150Hz/50Hz switch - Sets the frequency of the low shelf.
BASS dB control - Sets the amplitude of the low shelf.
PRESENCE KHz control
PRESENCE dB control- Sets the amplitude of the middle band.
15KHz/10KHz/5KHz switch - Sets the frequency of the high shelf.
TREBLE dB control- Sets the amplitude of the high shelf.
ENGAGE switch - Master bypass switch for the entire unit. Note that when the source signal is
mic or instrument, the bypass signal is taken from the preamp outputs. When the preamps
are set to a high gain, there is a potential for the bypass signal to be very loud.
Copyright © 2018, Overstayer Recording Equipment, Inc..
All rights reserved. All features and specifications are subject to change without notice.
To Next Page
Loading...