Ovlac Mini - SPARE PARTS IDENTIFICATION AND ORDERING

14
CONTENT
FRAME .................................................... 15
HEADSTOCK .......................................... 21
ADDITIONAL BODY ................................ 25
BODY SET ............................................... 27
CUERPO MINI ......................................... 29
SKIM BOARDS ........................................ 31
LANDSLIDE EXTENSION ....................... 32
FOLDING HYDRAULIC ........................... 34
HYDRAULIC SYSTEM............................. 35
WHEELS .................................................. 39
9. SPARE PARTS
Spare parts should always be ordered from your dealer and should
always include the following indications:
- Type, model and serial number of the plough.
These data are
punched on the identification plate with which every plough is equipped.
- Code number of the required spare part.
This will be found in the
attached spare parts list.
- Description of the part and required quantity.
- Means of delivery
. Transport expenses shall always be at the
consignor's charge.
- NOTE: The terms Right and Left
indicated on the descriptions, refer to
the plough when viewed from the rear. The spare parts components of
waste equipment, as shares, mouldboards, etc., are considered right if
they are mounted on a body which spills the soil to the right side and
viceversa.
- Note about the warranty
: The orders of spare parts in warranty should
always be clearly specified.
The Manufacturer will always sentence if
the spare parts are warranted in their replacement.
- Moreover, the warranty is suppressed if:
- The plough is repaired without authorisation from the
Manufacturer, or spurious spare parts, and inadequate bolts are
mounted.
-
The plough has been used beyond the specified power limit, or
anomalous manoeuvres and operations have been made.