Ovlac Mini - SETTING UP AND ADJUSTING THE PLOUGH; MOULBOARD PREPARATION FOR USE; TRACTOR HITCHING PROCEDURE

8
Fig.4
4. SET TO WORK
4.1 –MOULBOARDS
Before starting work, the paint on the mouldboards should be
removed to avoid that the soil remains adhered.
4.2 – HITCHING TO THE TRACTOR
The OVLAC ploughs are designed to fit to the 3-point universal
coupling of any farming tractor.
The cross shaft can be supplied in two different lengths (centre
to centre):
Category II 900 mm.
Category III 1.000 mm.
The cross shaft must have the appropriate length to make the
drawing powers converge in the centre of the frontal axle, as shown
in (Fig. 5).