4
OWC Envoy
Device Setup
5
4
4. Reseat the bottom cover, then use
a Torx T5 driver to install the two screws
mentioned in Step 1. The longer screw
goes on the left, the shorter screw goes
on the right. Avoid over-tightening the
screws, as they may strip.
5. Remove the backing on each of the
adhesive rubber feet and place the sticky
side of each foot into one of the grooves
on either end of the Envoy,
as shown.
The assembly process is now complete.
To Next Page
Loading...
Need help?
General
