To Next Page

To Previous Page

OWC Envoy

Device Setup

SSD Compatibility

- The OWC Envoy is compatible ONLY with the original Apple SSD from the MacBook Air.

Any other third-party SSDs, including OWC SSDs, are NOT compatible.

- The Envoy for MacBook Air 2010–2011 works ONLY with the Apple SSD from those

specic models.

- The Envoy for MacBook Air 2012 works ONLY with the Apple SSD from that specic model.

NOTE: The pictures shown in these instructions use the Envoy for MacBook Air 2010–2011. The assembly

process is identical for the 2012 version, except the black SATA connector is slightly wider.

2.1 Assembly

1. Turn the Envoy enclosure upside

down, as shown below. Note that

the two included screws are different

lengths. For now, set these

screws aside.

2. Remove the bottom cover. The circuit

board will be slightly loose; when fully

assembled the board is held in place

by pegs on the bottom cover.

3. Insert the Apple SSD into the black

SATA connector on the circuit board,

as shown below. The connector is

notched so that only one orientation

can be used.

DEVICE SETUP

OWC Envoy User Manual

Other manuals for OWC Envoy