OWC EXPRESS
SYSTEM SETUP
4
5. Make sure that the top cover is lined up exactly with the bottom case, then hold the
top cover and the bottom case with one hand and flip over the OWC Express. Use a
Phillips screwdriver to install the remaining two longer coarse-threaded screws in the
screw holes circled in the picture below. This will secure the top cover to the bottom
case.
6. The assembly process is now complete. You can begin using your OWC Express right
away. For instructions on how to use the OWC Express to migrate data from one
drive to another, go to: h t t p:// www.macsales.com/migration
To Next Page
Need help?
General