OWC DIGITAL - MERCURY HELIOS
DEVICE SETUP
3
DEVICE SETUP
These are static-sensitive devices. They are susceptible to invisible dam-
age from static electricity if not protected during assembly.
We recommend proper grounding by using a grounding strap. Make
sure to work in a clean and static-free area, and avoid wearing clothing
that retains static charges.
2.1 ASSEMBLY
1. Remove the OWC Digital Mecury Helios® from its packaging and place it on a soft surface.
2. Loosen the two thumscrews on the rear panel of the Helios, circled below in red. You can
use your hands or a Phillips screwdriver. These are captive screws, so you will not be able
to remove them from the enclosure. Simply loosen the screws until they spin freely.
To Next Page
Loading...
