11 GB/IE
coming into contact with battery acid
should be rinsed off with copious amounts
of water and / or a doctor contacted if
necessary!
Before initial use
Put the batteries first into the outdoor
sensor, then into the temperature
station.
Note: Before initial use, remove the protective
film from the device display.
General information
CAUTION! When choosing where to
position the temperature station, make sure
that it is not exposed to direct sunlight, vibra-
tions, dust, heat, cold or moisture. Do not place
the temperature station or external sensor near
to heat sources, e.g. radiators, as this may re-
sult in damage to the instruments.
Place the temperature station on the ac-
companying stand
25
.
Please ensure that neighbouring devices
are not operated at the same frequency
of 433 MHz. Such devices may cause
interference to the radio connection.
Do not place the devices next to or on
metal plates. Otherwise the quality of ra-
dio wave transmission may be reduced.
To Next Page
Loading...
Need help?
General
