15 GB/IE
Temperature station
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
27
into the drilled hole.
Using a crosshead screwdriver, screw the
screw
26
into the dowel.
Hang the temperature station by placing
the hanger
23
on the screw.
External sensor
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
32
into the drilled hole.
Using a crosshead screwdriver, screw the
screw
31
into the dowel.
Hang the external sensor by placing the
hanger
29
on the screw.
Note: Ensure that the external sensor does
not come into contact with water or direct
sunlight. Electronic devices may adversely
affect the wireless signal reception.
Setting the language / time
zone / time / date manually
The reception of DCF radio signal where the
temperature station has been positioned may
become degraded or interrupted. If this hap-
pens you can set the device manually.
1. Press and hold down the CLOCK button
22
for about 3 seconds.
To Next Page
Loading...
Need help?
General
